Description
These studs are ideally for use with older U.S. domestic vehicle hubs that require 1/2" knurl, usually with 7/16" thread, where converting to metric thread is desirable.
Alternately, they can be used as conversion studs for many hubs that normally use M12 wheel bolts, common on German vehicles.
Ensure that studs are pressed, or hammered in from the rear, with sufficient force to seat completely.
Features:
- Material: 40Cr heat treated
- Thread: M12x1.25
- Length: 60mm below the head
- Knurl length: 9mm
- Knurl diameter: .500-.503"